IronBits
03-22-2003, 03:24 PM
I took a good running A7N8X ASUS board,
removed the good running xp2400 from it and cleared CMOS.
Put in a new xp2400, starts up for 3 sec and power goes off...
I have fans plugged into all power connectors...
Tried another xp2400... same thing.
Tried with two different xp2600 procs, same problem.
Put the original one back in, clear CMOS again, same problem again :swear:
It just powers on for 3 seconds then shuts off...
The only thing I changed was the cpu's...
What is going on? I can't even get into CMOS :bang:
I've seen this behaviour before, but don't remember what it takes to get past this BS.
Clues anyone?
removed the good running xp2400 from it and cleared CMOS.
Put in a new xp2400, starts up for 3 sec and power goes off...
I have fans plugged into all power connectors...
Tried another xp2400... same thing.
Tried with two different xp2600 procs, same problem.
Put the original one back in, clear CMOS again, same problem again :swear:
It just powers on for 3 seconds then shuts off...
The only thing I changed was the cpu's...
What is going on? I can't even get into CMOS :bang:
I've seen this behaviour before, but don't remember what it takes to get past this BS.
Clues anyone?