P-1 coordination thread - discussion

[hhh]

Does mprime have to do the second pass tests as well, because on this machine I have it running for a while, but I didn't change the memory setting, so it doesn't do second pass tests. How bad is that?
On my other machine, I actually opted for a range that seems to be passed by PRP. But then it will be finished by now, so I will send the results in this evening.

Stage2 is needed to find factors. In your mprime directory, look for a bunch of files called (one letter)(long number), I hope you get what I mean. it could be something like
z5123875 or
f1329834

if they are there, you probably can just put in the stuff for worktodo.txt again, change your memory settings, and it will start to do all the stage2 for the tests. If that fails, it is proably better to drop that range and to do another one with larger memory settings, rather than redoing all the stage 1 work.

H.

[balachmar]

OK, thanks for the clarification. I know what you mean with the files.
I will copy the lot to another machine, since this machine is doing some other work at the moment. I hope that the other machine will be able to finish it. OK, I first tried to get it to run on this machine and that works.
So I will complete it normally.

[balachmar]

I'll post here not to trash the other thread, but my range resulted in one factor, not two!
14920000 14921000 balachmar 1 [complete]

[Joh14vers6]

I'll post here not to trash the other thread, but my range resulted in one factor, not two!
14920000 14921000 balachmar 1 [complete]

I can not see the factor in the stats. Is the factor big? Then post it here.

[glennpat]

I had posted that I had 2 factors in the range 15060000 15070000. Maybe it should of only really been 1. The factor 8058533177897161|24737*2^14910223+1 I turned in was new and saved to the data base, but I see today I did not show up in my stats. I looked in the stats for everyone and saw:

5189.734T 21181 15307772 3800310.858 Sat 12-Jul-2008 Mon 21-Jul-2008 35.000 PrimeGrid

Mine was found after the one PrimeGrid had found so it didn't really count for me.

[balachmar]

I can not see the factor in the stats. Is the factor big? Then post it here.

Too bad I only read this now. I don't think I have the values of the factor anymore...
And as far as I know the submission page accepted the factor...
mm strange...
Anyway, I'm getting a bit fed up with P-1 did a few like 40 lines of work and still no result... (As in points for the team and tests saved...)

[[DPC]Frentik]

Sorry if asked before but these are the steps I performed to do P-1 factoring and I want to make sure it's done properly

- Created account at www.seventeenorbust.com and joined my team there.
- downloaded latest prime95 version from www.mersenne.org
- reserved a range in the appropriate thread and saved it in the prime95 folder
- started prime95 and choose "join GIMPS" (then I had to fill in a username/email etc but i assume this is only used if you do mersenne prime finding? <- insecure on this part)
-stopped prime95, added the results.txt=fact.txt to the prime.ini file and restarted prime95.

It's running now and since its working on the first value from the worktodo.ini file I assume this part is correct so far.

Now when I find a factor I only have to submit it at www.seventeenorbust.com/sieve? And when the range is done, I'll post it in the coordination thread.

[Joe O]

If the factor is larger than 2^64 then you have to submit it here.