IronBits
03-07-2004, 01:14 AM
What does all this mumbo-jumbo mean?
# PeerNode Network Monitor Server
# Enter the IP address of the PeerNode Network Monitor Server
# The server uses port 3434, so you may need to open it on your firewall
# Use an IP address such as 127.0.0.1 if you're running a PeerNode monitor
# Use netmon=* if you are *not* running a PeerNode monitor. If you set an
# IP address and you're not running a monitor - then you'll actually slow
# down your client as it tries to connect to a monitor that isn't running!!
#netmon=*
No matter what I put
netmon=*
netmon=*192.168.2.5
netmon=192.168.2.5
I even try to change it under advanced networking and enter it in there, click ok, and when I check back, it's still at the default of 0.0.0.0 and when I restart, it says monitoring is going to port 127.0.0.1 !
Nothing works, cbmoc.jar gets nothing and neither does pnnetmon.exe
What's a fella gotta do to get it to work with these new cb clients? :bang:
# PeerNode Network Monitor Server
# Enter the IP address of the PeerNode Network Monitor Server
# The server uses port 3434, so you may need to open it on your firewall
# Use an IP address such as 127.0.0.1 if you're running a PeerNode monitor
# Use netmon=* if you are *not* running a PeerNode monitor. If you set an
# IP address and you're not running a monitor - then you'll actually slow
# down your client as it tries to connect to a monitor that isn't running!!
#netmon=*
No matter what I put
netmon=*
netmon=*192.168.2.5
netmon=192.168.2.5
I even try to change it under advanced networking and enter it in there, click ok, and when I check back, it's still at the default of 0.0.0.0 and when I restart, it says monitoring is going to port 127.0.0.1 !
Nothing works, cbmoc.jar gets nothing and neither does pnnetmon.exe
What's a fella gotta do to get it to work with these new cb clients? :bang: