ok i think im having kinda the same prob as this guy. maybe not.
MY prob is this: the cEM/s are about 316500.0 when i look at it in the client window.
but when its posted in the graph on the website it shows up as about 100000.0 .
why is this? is the website calculating this number differenty?
thanx
edit** here is what it says now. (lower b/c im runnin a few things).
just look at my user stats for a look at the graph. (Shifter2101)
if you look (on the site) at when i first started running SB you can see that it was at a higher cEM/s rate.
someone please explain this to me please.
Last edited by Shifter2101; 12-27-2003 at 01:33 PM.
The stats on the site are generated as a per amount of time graph. Meaning that if you only ran the cient for a few hours out of the day it'll only show the average rate you had. Also if you have don't have send intermediate blocks checked then it'll only update your work when it communicates with the server.
When were you assigned the test? The graph will only reflect the rate given in the client if you've been crunching the test 24/7 since you've got it. Looking at your screenshot, I'd guess you have, so I'm not sure :/
Check your pending test page to make sure that the test you're working on is there, and is updating properly. Averaging the total work done by the date the test was assigned should give you the values on the graph.
ive only got one test in the "pending". (the one im currently working on).
you guys are saying that i should turn the "send intermediate blocks" on?
also, is this a good rate for a p4?
yesyou guys are saying that i should turn the "send intermediate blocks" on?
it was not too bad with v1.11also, is this a good rate for a p4?
but you should definitely switch to v1.20 where SSE2-optimization for P4s are reenabled again, that should give you at least a 30% speed boost
will do.
im off to work as im typing this so ill do DL 1.2 later today.
can i install in the middle of a test?
(n/m.... ill wait till this current test is done b4 i install).
thanx ppl
Definitely!Originally posted by Shifter2101
can i install in the middle of a test?
[/B]
And there is no need to deinstall the old client before. Just make sure that the client is not running while you're installing the new one. Of course you need to install it into the same directory, otherwise the new client won't find your test...
downloaded the new client... 26% increase in cEM/s rate
Posting Permissions
Reply With Quote